Connection with target computer using ethernet board network simulink real time

Question

Jose Briceño 2018 年 9 月 19 日

0
リンク

この質問への直接リンク

https://jp.mathworks.com/matlabcentral/answers/419839-connection-with-target-computer-using-ethernet-board-network-simulink-real-time

編集済み: TJKoomen 2018 年 10 月 11 日

Hello,

I've seen that matlab suggest a PCI card ethernet connection with the target computer. https://www.mathworks.com/help/xpc/ug/command-line-pci-bus-ethernet-setup-multiple-target-computers.html

But is it possible to use the ethernet bus in the mother board of the target computer. That is because I don't have a ethernet card available.

I'm using matlab R2017a

0 件のコメント
-2 件の古いコメントを表示-2 件の古いコメントを非表示

サインインしてコメントする。

サインインしてこの質問に回答する。

Answer 1

TJKoomen 2018 年 10 月 11 日

0
リンク

この回答への直接リンク

https://jp.mathworks.com/matlabcentral/answers/419839-connection-with-target-computer-using-ethernet-board-network-simulink-real-time#answer_340861

編集済み: TJKoomen 2018 年 10 月 11 日

This is possible; however the ethernet controller on your motherboard will have to be of a certain brand/familiy for it to be supported by Simulink Real Time. These families are listed in the dropdown "Ethernet Device Settings" in slrtexplr, Intel is generally very well supported. I use the following Intel ethernet cards in Simulink Real Time targets: