Arduino ReadDigitalPin all ones
1 回表示 (過去 30 日間)
古いコメントを表示
Hi, I'm trying to connect an arduino to matlab to collect data from the digital pins. I am sending data to pin D3, but when I say readDigitalPin(a,'D3') in matlab it just gives me 1. My code is below, any advice would be appreciated.
if true
a = arduino('com8', 'uno');
t1 = 0;
dt=[];
dv=[];
tic
for i =1:500
i;
tic;
v = readDigitalPin(a,'D2');
dT = toc;
t1 = t1 + dT;
dt(i) = [t1];
dv(i) = [v]
pause(0.5)
end
end
1 件のコメント
Walter Roberson
2018 年 5 月 4 日
Have you put an oscilloscope onto the pin to verify that the value goes lower than the threshold at some point, and does so for longer than the hold time of the sampling hardware?
Is D2 configured as a continual read or is it configured as triggered by edge detection? If triggered then what are the reset conditions?
回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で MATLAB Support Package for Arduino Hardware についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!