How to design a BAJA transmission system ?

3 ビュー (過去 30 日間)
Suraj Singh
Suraj Singh 2018 年 3 月 31 日
コメント済み: Suraj Singh 2018 年 4 月 10 日
I am a beginner, I made this (attached simulink design pic ) while learning from other videos and some basic knowledge of the data. Can you help me with this ? How can I improve this system. (It is baja designed transmission system, consisting a engine, cvt and single reduction gearbox with no differential). I don't know about r port in "Variable transmission ratio" block. Here's a simulink file attached.
  3 件のコメント
Suraj Singh
Suraj Singh 2018 年 3 月 31 日
Yeah. thanks !!!

サインインしてコメントする。

回答 (1 件)

Veer Alakshendra
Veer Alakshendra 2018 年 4 月 5 日
編集済み: Veer Alakshendra 2018 年 4 月 5 日
The input to r port is the gear ratio as the function of time. In your model you have used a signal builder block to represent gear ratio as a function of time which is a correct approach. Just make sure that you have taken the correct gear ratio.
Regards,
Veer
  1 件のコメント
Suraj Singh
Suraj Singh 2018 年 4 月 10 日
I have tried giving a contant value to the ratio (r port of VTR), but results are not showing up.

サインインしてコメントする。

カテゴリ

Help Center および File ExchangeSimulink についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by