Info
この質問は閉じられています。 編集または回答するには再度開いてください。
The USB interface of PZSDRCC-BRK-G carrier board doesn't work with the Matlab/Xilinx firmware
1 回表示 (過去 30 日間)
古いコメントを表示
Hello All,
I'm struggling with starting the USB connectivity of PicoZed SDR2 PZSDRCC-BRK-G carrier board with combination with the Matlab firmware, which supports Communications System Toolbox™ Support Package for Xilinx® Zynq®-Based Radio, but without any success till this moment.
USB works perfectly with the Analog Device's zynq-picozed-sdr2-brk firmware but not with the Matlab's one.
When I insert USB pen drive there is no any indication for connectivity. Nothing from fdisk -l, lsusb and into the /dev/bus/ directory.
Has anyone encountered the same issue before?
Thank you so much for any idea how to overcome that issue.
Regards,
Ethan
0 件のコメント
回答 (4 件)
Martin Enderwitz
2018 年 2 月 16 日
Hi Ethan,
If I understand correctly, you're trying to use the USB-OTG to port on the carrier to provide the connection between your local host and remote target.
This is not a supported workflow using the Xilinx Zynq-Based Radio hardware support package (and it's firmware), which requires a dedicated Ethernet link between the host and target.
Please see the setup instructions here for more info: https://www.mathworks.com/help/supportpkg/xilinxzynqbasedradio/ug/manual-host-radio-hardware-setup.html
Regards,
Martin
0 件のコメント
Martin Enderwitz
2018 年 2 月 16 日
Hi Ethan,
Sorry, I misunderstood your original question.
At present, the MathWorks firmware does not currently support this workflow.
Regards, Martin
0 件のコメント
参考
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!