Motion sensor in SimDrivelines always shows ZERO Angular Acceleration

Hello all,

I'm using SimDriveline for simulating an automatic transmission. The problem is that I can not measure the angular acceleration by using the motion sensor, on the scope the output of Angular Acc. port is always ZERO (while it's giving angular velocity correctly). So, anybody faced this problem? Any help is appreciated.

Thank you Tuan Ngo

Answer 1

[Steve Miller]

Without your model it is hard to be sure. Make sure you have zoomed in enough on the Scope - sometimes if the units are set poorly, it can look like a zero when it is actually a non-zero value.

--Steve