How to limit accuracy of simscape multibody output

1 回表示 (過去 30 日間)
Daniel Stuewe
Daniel Stuewe 2017 年 5 月 2 日
回答済み: Wilson A N 2017 年 5 月 8 日
I have a simulation using Multibody that has a response that is showing far too much precision and I think it is affecting my run time. Is there a way to limit this? Here's what the scope is showing (units are in inches).
Kind Regards, Dan

回答 (1 件)

Wilson A N
Wilson A N 2017 年 5 月 8 日
As I see from the figure, there is only a very small change in the y-axis (that is only after the 10th place after the decimal point). So if you want to decrease the values seen in the scope, you may obtain only a line. Now in order to increase the range of values displayed on the scope, you can right-click on the scope, and navigate to 'Configuration Properties'. Here you can specify the Minimum and Maximum Y-Limits.
But regarding your problem, I highly doubt that this will affect your runtime.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by