Problem related to powergui block

8 ビュー (過去 30 日間)
saptesh pandit
saptesh pandit 2016 年 10 月 11 日
回答済み: Prabhat Singh 2020 年 1 月 13 日
whenever I run my model following errors occur how do I solve these.
1)Error in port widths or dimensions. Output port 1 of
'practice/powergui/EquivalentModel1/Gates/From2' is a [1x2] matrix.
2)Error in port widths or dimensions. Invalid dimension has been specified
for input port 2 of 'practice/powergui/EquivalentModel1/Gates/Mux'.
I am using 1x2 size matrix which is the requirement. How do I solve these problems.

回答 (2 件)

ALBERT ALEXANDER STONIER
ALBERT ALEXANDER STONIER 2016 年 10 月 13 日
It is only because of the dimensions which you have specified for the signal. Kindly change the dimensions and proceed with.
  1 件のコメント
Jasmine Jones
Jasmine Jones 2018 年 4 月 17 日
I have tried to edit powergui and I still have the same errors? My simulation will not work without it but with the powergui in I get the fault mentioned above?

サインインしてコメントする。


Prabhat Singh
Prabhat Singh 2020 年 1 月 13 日
I am not able to see FFT analysis by powergui block. Simulation run but after clicking on FFT analysis it is not sowing the resuts. I have made all the settings properly is scope also.

カテゴリ

Find more on Modeling in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by