How to read 2 analog inputs in ti c2000 using simulink and multiply them?
1 回表示 (過去 30 日間)
古いコメントを表示
Working on a project which reads current and voltage using sensors connected to C2000...These signals are then multiplied to get the power...How to read these signals and multiply them using Simulink and where the final result gets stored?
1 件のコメント
Gautam Mohan
2016 年 4 月 1 日
Hi Nitish,
To interface with the C2000 microprocessor using MATLAB, you will need to download the corresponding Hardware Support Package. I suggest viewing or testing some of the examples to get started and see the commands used to read the signals on the C2000. You should be able to use a Simulink Product block to multiply the signals. Hope this helps!
回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Downloads についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!