How to linearize a switching model of buck-boost converter?

5 ビュー (過去 30 日間)
Puneet
Puneet 2016 年 3 月 8 日
コメント済み: Arkadeep Deb 2021 年 6 月 10 日
I have a buck-boost converter (switching model) and I want to linearize my converter around some steady state operating condition. I know how to get analytically derive the transfer function of the model but I want to verify my transfer function (or characteristics) with what I get from linearization function. I know PLECS has perturbation and response small signal blocks and then you can do impulse response to get bode plots. How to get the linearized model of my converter and thus obtain any kind of plots like bode? I am attaching the switching and average model of my buck-boost converter. Any help and clues are much appreciated.
Thanks Puneet

回答 (2 件)

Rakesh Chavan
Rakesh Chavan 2016 年 3 月 14 日
Hi,
You can use the Linear Analysis tool for linearizing your model. Some examples and documentation for the same can be found at the following link: http://www.mathworks.com/discovery/linearization.html
You can set the operating points as needed as well as observe the responses in terms of Bode plots. You may also want to look at the following link for Frequency Response Estimation Using Simulation-Based Techniques: http://www.mathworks.com/help/slcontrol/examples/frequency-response-estimation-using-simulation-based-techniques.html
Hope this helps.
--
Regards
Rakesh
  2 件のコメント
Puneet
Puneet 2016 年 3 月 14 日
Thanks for response. I have already looked at both of these examples. The frequency response estimation technique that has been demonstrated in your link 2 runs my computer out of memory after an hour or two. Also I found out that I can get the transfer function from the average model easily than Switching model. I still don't know how to get the transfer function for the switching model though (still searching for it). Meanwhile I have one more question on linearization:
When you click "Linearize At" it asks to give a vector [0 1], also there is an option for "Taking Snapshot" and to "Trim Model" which opens a variable dialog box. What is the difference between all three techniques? Can anyone help?
Rushi Jariwala
Rushi Jariwala 2017 年 12 月 25 日
Hi Puneet. Can you share how you did frequency response estimation for the averaged model? Is it the same as described in the 2nd link?

サインインしてコメントする。


Sathish Lakshmanan
Sathish Lakshmanan 2019 年 1 月 29 日
HI I am also searching for Linearization of Switching models. I have AC supply , Input Filter, Vienna rectifier(PFC correction) and DC-Dc Resonant converter in my model. To derive the transfer function fot this whole model looks complicated. If somebody can help me how to derive the transfer function directly from the Simscape Model. I will derive the transfer function for each model and finally combine the model.
Thanks in Advance
  1 件のコメント
Arkadeep Deb
Arkadeep Deb 2021 年 6 月 10 日
Hello, did you manage to solve the problem? I am having the same problem as mentioned above. Can you please help me?

サインインしてコメントする。

カテゴリ

Help Center および File ExchangeTrimming and Linearization についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by