simdriveline (Basic motion torque and forces modelling). Not getting simulation of two spinning inertias
1 回表示 (過去 30 日間)
古いコメントを表示
When I am trying to build the subsystems for Motion sensor (base and follower) and I am not getting the connection between the mechanical ports and physical signals correctly. I tried all the possibilities but its not happening. Please help me to solve that.
Thank you in advance.
1 件のコメント
Sebastian Castro
2015 年 8 月 17 日
Do you have a screenshot of your model and any results/error messages to share with us?
回答 (1 件)
Steve Miller
2020 年 8 月 4 日
This example shows a common use of the motion sensor blocks:
The distance between R and C is output at port P. You define the initial offset between these two ports in the Motion Sensor block. You connect the Phyiscal Signal to Simulink Converter block to the sensor in order to get a Simulink signal that you can connect to a Scope or a control system.
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Simscape Driveline についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!