Show branch measurements of voltage and current

Hi, I'd like to know where can I see the results of the branch voltage and current when you activate them for the resistor as shown in the pucture. I'm not talking about adding voltage and current sensors but just where can I see them after the simulation just activating those measurements as in the pics.

Answer 1

[Sabin]

For the Specialized Power Systems you will need to place a Multimeter block in your model to display the selected measurements during the simulation. In the Available Measurements list box of the Multimeter block, the measurement is identified by a label followed by the block name, for example a branch voltage will show like Ub:Series RLC Branch.

[Michel]

Thanks. Your replay has been very helpful.