TI Radar Toolbox with DCA1000EVM Connection - Continuous error occurs when attempting to connect with an Ethernet cable
6 ビュー (過去 30 日間)
古いコメントを表示


This is our hardware Setting
We are using IWR6843ISK with DCA1000EVM capture board


This pictures are our device manager and Fixed IPv4 Settings


This is our Inbound and Outbound Firewall settings

We followed many guide to connect DCA1000EVM capture board but we are contiunously experiencing error like this
How can we solve this error?
0 件のコメント
回答 (1 件)
Deep
2024 年 10 月 23 日
Your network adapter and Windows Firewall settings indicate that the local IP address of your Windows machine is "192.168.33.30," while the IP address of your remote device (DCA1000EVM) is "192.168.33.180." However, your MATLAB setup for the DCA1000EVM is currently attempting to connect to your local Windows machine. Please update the configuration to connect to "192.168.33.180" instead.
For additional troubleshooting assistance, please refer to this guide on setting up and connecting with the DCA1000EVM: https://www.mathworks.com/help/radar/troubleshooting-dca1000evm.html
3 件のコメント
Gayatri Menon
2024 年 11 月 14 日
Hey,
Can you try the below:
- Run the ipconfig command in the Command Prompt and share the output.
- Try disconnecting the Radar from the DCA1000 and then:
Connect the DCA1000 to a power supply
Ensure that switch SW3 is set to DC_JACK_5V_IN and SW2.5 is in the SW_config position
Wait for 10-15 seconds, then attempt the test connection again.
3. Try disabling all other network connections, including Wi-Fi, except for the connection to the DCA1000 network. (This is the least probable cause, try this if step 2 doesn’t work).
参考
カテゴリ
Help Center および File Exchange で Waveform Design and Signal Synthesis についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!