Adsorption process in Simulink

How to create a switch command between adsorption and desorption in Simulink?

[Rahul]

Hey @Ababacar Thiam, can you share your Simulink Model, or describe your use case, that'll help in better understanding the isssue.

[Ababacar Thiam]

Thanks for your answer Rahul. We first simulated adsorption in one block. Then we simulated desorption in another block. We seek to regroup the two blocks so as to have the desorption-adsorption sequence.

Answer 1

[Altaïr]

Hi @Ababacar Thiam,

To switch between the two subsystems (adsorption and desorption) based on a control signal, the ‘Switch’ block can be used. The control signal can be generated in a couple of ways:

1. Using ‘Relational Operator’ and ‘Logical Operator’ blocks if the switching logic is simple.
2. For more complex switching logics, a ‘Stateflow’ chart can be used.

You can learn more about the ‘Switch’ block in the following documentation page.

https://www.mathworks.com/help/simulink/slref/switch.html

Here’s an example for the ‘Switch’ block that outputs the absolute value of a biased sine wave. The below model switches between ‘subsystem1’ and ‘subsystem2’ depending on the value of ‘controlSignal’.

The output seen in the scope would be as follows:

You can refer to the attached model for further assistance. To switch between several subsystems, the ‘Multiport Switch’ block can be used. Feel free to check out the following documentation page.

https://www.mathworks.com/help/simulink/slref/multiportswitch.html

I believe this will assist you!

[Ababacar Thiam]

Thanks a lot Ashok, I will try to the simulation with your explications