Simulink real-time model execution stops at 1st iteration randomly
1 回表示 (過去 30 日間)
古いコメントを表示
Hello,
I am using Simulink Real-time for running a vehicle model with actuator inputs given through an ADC(NI PCI-6229). The states are sent over serial. When I build this model and download it to an i386 target it randomly fails to start and gets hung up on the 1st iteration. I have done the following to try to resolve the issue since i have not found any error code for the same:
- Changed my MATLAB 2014a setup to a differnet PC.
- Changed the target PC
- Disconnected all connected hardware
- Changed the SCB-68 connection block
- cleaned all generated files and built the model again
The model runs when I bypass the Analog inputs with constants. The proves that there is some issue with the analog data acquisition block, but i may be horribly wrong. Has anybody come across this issue in the MATLAB 2014a pack?
Swaroop
0 件のコメント
回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Target Computer Setup についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!