delete zero in signal

5 ビュー (過去 30 日間)
洪宇
洪宇 2024 年 6 月 19 日
回答済み: Aquatris 2024 年 6 月 19 日
My current signal is shown in the figure, which can be seen as continuous steps. I want to obtain the vertices of these peaks and then connect them one by one to form a discount, becoming a new signal that can be input into other modules of Simulink. How to achieve this

サインインしてこの質問に回答する。

回答 (1 件)

Aquatris
Aquatris 2024 年 6 月 19 日
Your question is a bit ambigious but if you just want to remove the 0 s from the signal you can use a switch and delay block to ignore 0 values.

カテゴリ

Help Center および File Exchange で Signal Attributes and Indexing についてさらに検索

タグ

製品


リリース

R2023a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by