Raspberry Pi and Simulink setup error

Hello,

I'm trying to connect a Raspberry Pi B+ to use through Simulink. I have downloaded and installed the Simulink Support Package and connected the Raspberry to my computer using an Ethernet cable. I tested the connection with 'ping' at the terminal, and it's working. While configuring the Simulink Support Package, I noticed that the interface differs from that in the tutorials. There is no option to set up hardware with the MathWorks Respbian Image. I tried to use the new interface with my Raspberry but without success. The SSH is enabled in the Raspberry, and the user and password are ok. I attached a print of the error.

Would you please give me some guidance on how to proceed?

Thanks

New interface

Interface in the totorials

Error

[Prasanth Sunkara]

The password field sometimes does not take in the input correctly if you enter your passowrd quickly. Could you try to see if this is not the case by entering the password details a bit slowly?

Also, use a tool like putty to see if you can SSH to the Raspberry Pi to confirm there are no SSH issues?