Error:External Mode Open Protocol Connect command failed Caused by: Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNEC

82 ビュー (過去 30 日間)
CHIANG
CHIANG 2024 年 5 月 6 日
コメント済み: Vamsi krishna 2025 年 1 月 17 日 18:42
External Mode Open Protocol Connect command failed
Caused by:
  • Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command
How To fix this problem?
  1 件のコメント
Vamsi krishna
Vamsi krishna 2025 年 1 月 17 日 18:42
Did you try to fix this ? I'm getting the same error on f28379d control card. However, this error only appears in the "Monitor and Tune" mode and not during "Bulid, Deplay & Load"

サインインしてコメントする。

回答 (1 件)

Venkat Siddarth Reddy
Venkat Siddarth Reddy 2024 年 5 月 6 日
編集済み: Venkat Siddarth Reddy 2024 年 5 月 6 日
Hi Chiang,
Refer to the following post regarding this query, since this consolidates various approaches in solving the issue:
I hope it helps!
  1 件のコメント
CHIANG
CHIANG 2024 年 5 月 6 日
"I didn't encounter any XCP issues with the following model."
Using the same environment.
WHY?

サインインしてコメントする。

タグ

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by