Could not connect to Zynq hardware board using IP address 192.168.1.101.

12 ビュー (過去 30 日間)
koushik
koushik 2024 年 4 月 9 日
コメント済み: Manikanta Aditya 2024 年 4 月 9 日
Could not connect to Zynq hardware board using IP address 192.168.1.101.
Check that your device is connected to a LAN or direct network connection accessible from the MATLAB development computer
  2 件のコメント
Manikanta Aditya
Manikanta Aditya 2024 年 4 月 9 日
As mentioned, try checking your connection as well, and ensure that the USB cable is plugged into the ‘USB-to-UART’ port of the hardware and the power switch is turned on. If this error persists, switch off the hardware, wait for 10 seconds, switch on the hardware and then repeat this step.

サインインしてコメントする。

サインインしてこの質問に回答する。

回答 (0 件)

カテゴリ

Help Center および File Exchange で Targeting FPGA & SoC Hardware についてさらに検索

タグ

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by