Incorrect display of figure when rendering with vector format

Hi,

I have encountered an annoy issue related to the mentioned topic. A set of plotted items show plugged into some other items, seen the attached screenshot. Even though I can change the render engine into the bitmap format, the resolution of the exported image is not sufficient with 600 dpi. Is there any solution to correct this issue by keeping with the vector rendering? The correlated .fig file is attached.

I very appreciate it if you can give any advice, thanks in advance.

Gu

Answer 1

[Sumukh]

Hi Jue,

It appears that the figure is not being rendered properly at your end. This issue is not reproducible at my end as the images are being rendered without any issues with the “Export Setup” option in R2023b, regardless of the type of rendering and resolution chosen. This could be due to some low-level graphics error caused by outdated graphics drivers. You can refer to the following article to troubleshoot the issue and retry rendering the image again:

https://www.mathworks.com/matlabcentral/answers/157894-resolving-low-level-graphics-issues-in-matlab

I hope this helps in resolving the issue.

[Jue Gu]

Hi Sumukh,

Thank you for your test and answer. I have tried the solutions in your provided link. However, it's still not work. I tried both the hardware and software configurations on OpenGL rendering, please see the screenshots. I am not sure what's going on at my end.

1. Hardware rendering with AMD Radeon RX6500 XT graphic card and the latest driver version.

2. Software rendering with the default configuration of MATLAB and OS.