Simscape Torque Sensor output is zero

11 ビュー (過去 30 日間)
Felix
Felix 2024 年 2 月 22 日
コメント済み: Felix 2024 年 3 月 25 日
I'm simulating the simscape PMSM.
I set a fixed angular velocity via a Ideal Angular Velocity Source.
I want to measure angle via an Ideal Rotational Motion Sensor and torque via an Ideal Torque Sensor. I cannot find a configuration of the three blocks that will lead to a converging simuation and a measured torque that is not zero (despite phase currents flowing).
Here is my set up: (the ports R C are connected to the PMSM RC ports)
I read other threads on the issue of torque and roatinal sensing but no configuration of the two sensors lead to valid measurements and a converging simulation
Do you have suggestions on how to connect the sensors and source?
Many thanks!

採用された回答

Steve Miller
Steve Miller 2024 年 2 月 23 日
Your angular motion sensor should be connected between shaft and a Mechanical Rotational Reference (NOT in series).
Your torque sensor should be connected in series between the angular source and an inertia. Make sure your motor has inertia or a rotational inertia.
--Steve
  1 件のコメント
Felix
Felix 2024 年 3 月 25 日
Thank you Steve!
This setup works for me:

サインインしてコメントする。

その他の回答 (0 件)

カテゴリ

Help Center および File ExchangeSimscape Multibody についてさらに検索

製品


リリース

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by