Gettting an error when trying to run the "Exchanging WiFi Data and Using ThingSpeak with STM32L475VG Discovery Board" MatLab example

When running this example, the step where it is Run Host Model to Receive and Analyze Data in Task 1, the host model when ran gives me the following error.

I double checked the port and address and they are the same as the Local IP port of the WiFi send and recieve block on the target model. I am using a static IP address for the target hardware and set the remote address parameters of the host model TCP send and recieve blocks to that address.

Answer 1

[Madhu Varshini]

Hi , I tried running the example at my end. It works fine without any error.

Make sure the wifi setup and configuration parameter in WiFi is properly set.

If you are unable to resolve the issue, please reach out to Technical Support with model and reproduction steps.