Error "Initial conditions solve failed to converge" when connecting two Simscape Fluid examples

9 ビュー (過去 30 日間)
Fabian
Fabian 2023 年 11 月 23 日
回答済み: Rishi 2023 年 12 月 7 日
I am trying to connect two Simscape Fluid examples called "Residential Air Source Heat Pump" and "Stratified Hot Water Tank". The simulation works when both models are not connected. However, connecting the control signal of a circulation pump from Residential Air Source Heat Pump to Stratifiend Hot Water Tank (as shown in the screenshot below), I get the following error message:
I would really appreciate some help

回答 (1 件)

Rishi
Rishi 2023 年 12 月 7 日
Hi Fabian,
I understand that the Simscape solver is not able to solve the initial conditions target in your model.
You can try the following steps to fix your issue:
A similar issue has been addressed in this MATLAB Answer:
Hope this helps.

カテゴリ

Help Center および File ExchangeSimscape Fluids についてさらに検索

製品


リリース

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by