Working on Yagi PCB antenna

During the working on PCB antenna in the pcbAntennaDesigner, i have got a problem in simulating the antenna - that i'm out of memory:

The freq is 24G

Answer 1

[Raghunathraju]

Hi,

As per my understanding, you want to know how to resolve the ‘out of memory’ issue for your model in pcbAntennaDesignerApp.

Usually, the out of memory issue occurs when the mesh is dense and requires more RAM. You can resolve it by changing the mesh settings in Analysis Tab.

Follow the below steps to do that

1.Go to ANALYSIS >> Analysis Settings

2.Go to Mesh Settings >> Meshing Mode >> manual

After this, you can change the Max Edge Length, Min Edge Length and Growth Rate.

Now ,you will be able to simulate your design. You can click on Memory Estimate to know how much memory it would take to run your design and you can change the mesh accordingly.

For more information, you can go through PCBAntennaDesignerApp