add ylim and xlim only in the magnitude response of bode plot?
57 ビュー (過去 30 日間)
古いコメントを表示
hi guys,
How to add the ylim and xlim to the bode plot, magnitude only?
I havre added the ylim and xlim but the lines shows up in the phase plot and not the magnitude plot!
Cheers
0 件のコメント
回答 (1 件)
Robert U
2022 年 11 月 22 日
Hi SimTec,
If you are using bodeplot, you can have a look at bodeoptions()-command. There you can set the axis limits.
Kind regards,
Robert
2 件のコメント
Ben
2024 年 3 月 25 日
I have this issue as well. XLim is fine, I want them to be the same for both the magnitude and phase plots, but the YLIM applies the same limits to the phase and magnitude plots! There does not seem to be in bodeoptions a way to distinguish between the two plots.
Ben
2024 年 3 月 25 日
So the answer is simple... you add them in a cell like so:
opts.YLim = {[-20 10],[-50 150]}
参考
カテゴリ
Help Center および File Exchange で Get Started with Control System Toolbox についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!