How to properly configure ADALM Pluto?
7 ビュー (過去 30 日間)
古いコメントを表示
Hi, Im using ADALM Pluto to transmitt and recieve a signal. I generate a complex vector for a transmission in Matlab and trying to set up ADALM pluto transmitter and reciever with Simulink. But even since TX and RX ports of Pluto are connected with a cable, the BER is around 0.5 (whitch means that the recieved are totally different). Do you know how it can be fixed?
Thank you in advance
See screenshots for detailed information.
0 件のコメント
回答 (1 件)
Bhanu Prakash
2023 年 12 月 29 日
Hi David,
As per my understanding, you want to configure the ADALM-PLUTO device to reduce the Bit Error Rate (BER) in your model.
The value of BER (in your case 0.5) can be the result of multiple factors with frequency offset being one of the crucial factors. Frequency offset refers to the difference between the intended frequency and the actual frequency at which the device operates. This can lead to the reduction of Signal-to-Noise Ratio (SNR) thereby increasing the BER.
To avoid this, the transmitter and receiver (ADALM-PLUTO devices) are to be properly configured to have minimum frequency offset. Kindly refer to the following documentation on how to determine the relative frequency offset between two ADALM-PLUTO devices:
You can then calibrate the devices by adjusting the center frequency with respect to the frequency offset value.
Hope this helps.
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Analog Devices ADALM1000 Support from Data Acquisition Toolbox についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!