turn plot into a polyfit or polyval

4 ビュー (過去 30 日間)
rockstar49 2022 年 9 月 7 日
回答済み: Cris LaPierre 2022 年 9 月 7 日
Like to make this into polyval or polyfit so the points smooth out any noise
tried to use code, but seems it does not like taking a polyval of a FRF.
Any suggestions would help!
  1 件のコメント
dpb 2022 年 9 月 7 日
I presume FRF must be "Frequency Response Function", but how was it computed/where did it come from?
But, the problem in the above code is you've commented out the polyfit that is needed to compute a set of coefficients to pass to polyval and then just tried to use polyval on the x,y values of the to-be-fitted data instead.
The commented-out polyval line would be somewhat closer if hadn't commented out the polyfit, but it would then need to be
However, I'll note that a high-order polynomial such as this is highly unlikely to be satisfactory solution to the problem; you'll be wanting to look at some smoothing algorithm instead. Just what might be most appropriate would depend on what the actual data looks like which we do not have available to us.


回答 (1 件)

Cris LaPierre
Cris LaPierre 2022 年 9 月 7 日
In your figure window, select Tools > Basic Fitting
Use the UI to find an appropriate fit to your data. Once done, export the results to the workspace.


Find more on 2-D and 3-D Plots in Help Center and File Exchange





Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by