Simulink External Mode not working on Texas Instruments f28335 control card

i am trying to connect my f28335 card in external mode using simulink. Can you please tell me what could be the issue to solve the above problem.

there are two SW1(one switch) and SW2(four switches) . is there any specific switch configuration for external mode ?

Answer 1

[Ravi]

Hi SHIBU KUMAR,

When working with Simulink External Mode in TI F28335 control card, the SW1 switch should be in the OFF position. For real-time interactive testing, the JTAG interface can be used. Serial communication is not affected by setting the switch state to off position. It allows GPIO-28 to be used as GPIO. Setting the switch to off position is mainly used in JTAG emulation.

Hope this answer helps.

Thanks,

Ravi