Building a PID controller system

1 回表示 (過去 30 日間)
Pablo Cardenas
Pablo Cardenas 2015 年 1 月 2 日
編集済み: Pablo Cardenas 2015 年 1 月 2 日
Sorry to ask, but for a project I have to build this PID with the following specifications. I've used MatLab before, but I am not an expert:
English question
build a PID circuit, input is 0 to 5V. Simulate the Vout in Simulink.
Original Chinese question (I am an expat studying in China): PID 類比控制系統實作，在此再結合一PID控制器的實現類比電路，整個系統如下所示， 輸入0->5V 的步階訊號，計算PID 之值，利用Matlab 的Simulink 模擬輸出結果，實際建立以上電路及輸入訊號，利用示波器量出Vo 輸出結果
Original system: http://i60.tinypic.com/10e39qe.jpg
My work so far: http://i57.tinypic.com/2epiw4n.jpg
Questions:
1. Are those breaks or switches? What voltage should I make them close? 2. How can I control the voltage going from 0V-5V? 3. Should I make any corrections on the rest of my already built circuit?

サインインしてこの質問に回答する。

回答 (0 件)

カテゴリ

Help Center および File Exchange で PID Controller Tuning についてさらに検索

タグ

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by