Output doesn't seem right

Hi, so this is the output that I have so far, but the question has T-i and T-0 variables and I'm not sure what to do with those variables.

So I replaced T-i and T-0 with x and y but apparently the output is wrong. Apparently the goal is to produce a 3*3 matrix.

Answer 1

[Prateek Rai]

Hi,

The output does not seem right because you are mixing 2 things together. In the line 41 and line 42 of your code you are doing:

x = 20; y = 10; % Line 41
[x, y] = meshgrid(1:(n * m), 1:(n * m)); % Line 42

So because of the 42nd line, x is now not 20 and y is not 10 but rather output of the meshgrid.

This is why you have a warning at variable x and variable y at line 41. If you hover over them you will see messages like: "The value assigned to variable 'x' might be unused" and "The value assigned to variable 'y' might be unused" respectively.

To correct this, you can rather use variables like T_i and T_0 and save the respective values in these variables and don't mix it up with x and y.

So the code should look like:

x = 20; y = 10; % Line 41
[x, y] = meshgrid(1:(n * m), 1:(n * m)); % Line 42

You can refer to Variable Names MathWorks Documentation page to learn more on proper variables naming and avoid conflicting.