How can I use multimeter in the sequential circuit design with Xor gate and measure power in microwatts?
1 回表示 (過去 30 日間)
古いコメントを表示
I am designing a sequential circuit using XOR gate in matlab2014 but when I ran the following errors occurs:
1. Invalid setting for input port dimensions of 'AHpower/Demux'. The dimensions are being set to [-1]. This is not valid because the total number of input and output elements are not the same. Component: Simulink | Category: Block error
2. Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of 'AHpower/Multimeter'. Component: Simulink | Category: Block error How can I solve these errors?
1 件のコメント
Joel Van Sickel
2023 年 10 月 13 日
can you share your model? It probably has to do with how the multi-meter is set up and I can't tell just from the screenshot.
回答 (0 件)
コミュニティ
その他の回答 パワー エレクトロニクス コミュニティ
参考
カテゴリ
Help Center および File Exchange で Electrical Sensors についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!