How can I use multimeter in the sequential circuit design with Xor gate and measure power in microwatts?

2 ビュー (過去 30 日間)

Logan Harvey 2014 年 11 月 19 日

0
リンク

この質問への直接リンク

https://jp.mathworks.com/matlabcentral/answers/163384-how-can-i-use-multimeter-in-the-sequential-circuit-design-with-xor-gate-and-measure-power-in-microwa

コメント済み: Joel Van Sickel 2023 年 10 月 13 日

I am designing a sequential circuit using XOR gate in matlab2014 but when I ran the following errors occurs:

1. Invalid setting for input port dimensions of 'AHpower/Demux'. The dimensions are being set to [-1]. This is not valid because the total number of input and output elements are not the same. Component: Simulink | Category: Block error

2. Error in port widths or dimensions. Invalid dimension has been specified for output port 1 of 'AHpower/Multimeter'. Component: Simulink | Category: Block error How can I solve these errors?