How to generate a ramp up and ramp down sequence using Matlab Function in Simulink?

17 ビュー (過去 30 日間)
Amadou Bah
Amadou Bah 2021 年 11 月 25 日
コメント済み: Amadou Bah 2021 年 12 月 6 日
In the code i want to accelerate from 300rad/s to 302rad/s from t=5 to t=5.3. Then stay at 302 from t=5.3 to t=6.3. And then decelerate to 300rad/s from t=6.3 to 6.6.
However, I think my code is not right because I have another change in speed before i reached 302. Likewise during the deceleration.

採用された回答

Srijith Kasaragod
Srijith Kasaragod 2021 年 12 月 3 日
Hi Amadou,
I understand the issue you are facing is that there are two slopes generated in the ramp up and ramp down sections of the signal. One possible workaround is to specify the 'Max step size' option in Solver Configuration Parameters. Specifying a value of 0.1 enables the solver to track the signal changes effectively and only a single slope is obtained as intended. The solver might be missing significant behaviour from the default time step values, so changing the time step value could prevent the solver from taking too large a step.
Regards.
  1 件のコメント
Amadou Bah
Amadou Bah 2021 年 12 月 6 日
Hi @Srijith Kasaragod, you're right the solver setting was the problem. I reduced the step size, but I also had to switch from variable-step to fixed-step solver, then the problem is solved.
Thank you.

サインインしてコメントする。

その他の回答 (0 件)

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by