The SW physic model can not be shown in SimMechanics
1 回表示 (過去 30 日間)
古いコメントを表示
Hello everyone,
I meet a problem to put the SolidWorks model into simmechanics. All the processes are successfully completed until mesh_import(‘*.xml’). – I use the ‘Generation 1’.
But finally, the model is not show in explore of Simulink, only the coordinates of the centers masses are presented. There isn’t any error during the simulation. I have checked the STLs, there isn't mistake.
Is there anyone know how to deal with it?
Thanks at first !
0 件のコメント
回答 (1 件)
Steve Miller
2022 年 11 月 19 日
A very common issue that can occur here is that the units are set incorrectly. The solids are there but they are so small (or occasionally big) that you cannot see them. Check the units settings closely, and even try increasing/decreasing them just to see if that has an effect.
--Steve
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Bodies についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!