モデル化

ハードウェア接続用のモデルの準備、およびハードウェアプロトコルをサポートするためのブロックの追加

ブロック

Digital Output	Set the logical value of a digital output pin
Digital Input	Read the logical value of a digital input pin
RGB LED	Set the RGB LED to a desired color
Serial Receive	Receive an [Nx1] array of byte data on the UART
Serial Transmit	Send an [MxN] array of data to the UART
Analog Output	Send an analog output signal to PTE30 pin
Analog Input	Measure the voltage of an analog input pin
Servo Write	Drive the servo motor to the specified angle
Line Scan Camera	Read the data from a line scan camera
Momentary Switch	Read the state of a momentary switch
DIP Switch	Read the state of a DIP switch
DC Motor	Drive a DC motor in either direction
Potentiometer	Read the state of a potentiometer
Battery Read	Read the battery voltage of a battery connected to the TFC Shield
Battery Indicator	Display the battery voltage level with LEDs on the TFC shield
I2C Controller Read
I2C Controller Write
PWM Output	Generate square wave on the specified output pin

Model Configuration Parameters for NXP FRDM-KL25Z Board
Parameter and configuration options for creating and running applications on the target hardware.
Getting Started with Simulink Coder Support Package for NXP FRDM-KL25Z Board
This example shows you how to use Simulink® Coder™ Support Package for NXP FRDM-KL25Z Board to run Simulink model on a NXP FRDM-KL25Z board.
Code Verification and Validation with External Mode
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-KL25Z for code verification and validation using External mode.
Servo Control with NXP FRDM-KL25Z Board
This example shows how to use Simulink® Coder™ Support Package for NXP™ FRDM-KL25Z Board to control a servo motor connected to FRDM-TFC Shield.
Code Verification and Validation with PIL
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-KL25Z Board for code verification and validation using PIL. To run this model you need to have Embedded Coder®.
Read Acceleration Data from MMA8451Q 3-Axis Digital Accelerometer Using I2C
This example shows how to use Simulink® Coder™ Support Package for NXP™ FRDM-KL25Z Board to control the color of the RGB LED based on the orientation of the board.