Chiara
La Sapienza di Roma
2013 年からアクティブ
Followers: 0 Following: 0
Feeds
質問
Continuous input from keboard
Hello everyone, I am trying to implement a function which allows to capture input from keybaord but not just one time. I...
12年以上 前 | 0 件の回答 | 0
0
回答質問
how to replace a Timer with a Matlab function
Hi everybody. This is the idea that I would like to develop: now I have set a Timer where a step controls a switch, sending 1 ...
12年以上 前 | 0 件の回答 | 0
0
回答質問
How to control a simulink model by means of XPC target library?
Hi everybody, I am asking a huge help, because I have to finish my thesis project and I received license for R2012b XPC Target...
12年以上 前 | 0 件の回答 | 0
0
回答質問
How to set external mode simulation in R2012b?
Hello, I am using R2012b release and I would need to set external mode simulation in Simulink, but I can only see Normal, Accel...
12年以上 前 | 0 件の回答 | 0
0
回答回答済み
Use add_line on a line?
How can I specify left or right port to connect? In my case, in_src=get_param('new/source1', 'PortConnectivity') give...
Use add_line on a line?
How can I specify left or right port to connect? In my case, in_src=get_param('new/source1', 'PortConnectivity') give...
12年以上 前 | 0
質問
Can I add line after closing simulink model?
I have written code to build a simulink model. Since I want to add line afterwards, I use two variables, one of them is an array...
12年以上 前 | 1 件の回答 | 0
1
回答質問
Does anyone use xmltree functions?
Hello, I am trying to read and translate a substation description from xml file to a matlab file. I have installed a XML parse...
12年以上 前 | 0 件の回答 | 0
0
回答質問
Create model only if it doesn't exist
My script has this structure : sas='Model'; new=new_system('sas') open_system('sas') [...] save_system('sas') close_...
12年以上 前 | 1 件の回答 | 0
1
回答質問
Add line between blocks using handles
Hi, I would like to connect blocks using their handles. Do you know if it's possible? I know that add_line function uses po...
12年以上 前 | 2 件の回答 | 0
2
回答質問
Set_param Linear Transformers winding
I am trying to write code to set parameters in Linear Transformer mask, using SI units, but even though I set UNITS like SI, val...
12年以上 前 | 0 件の回答 | 0
0
回答質問
How to set properties of a line connecting two blocks
I am writing script to build model by command line. I have learnt how to set position for each block, but when I have to connect...
12年以上 前 | 0 件の回答 | 0
0
回答質問
Nominal Power value format
Hi, I'm trying to set Linear Transformer nominal power, but when I write the value 459e8, this error message come out: In ma...
12年以上 前 | 1 件の回答 | 0
