photo

Avinash Kumar


MVJCE

2015 年からアクティブ

Followers: 0   Following: 0

メッセージ

統計

  • Thankful Level 1
  • First Answer

バッジを表示

Feeds

表示方法

質問


Centroid of a estimated polygon
I have created a polygon using estimate geometry. I need to find the center/centroid of the polygon. I am using the below code t...

9年以上 前 | 0 件の回答 | 0

0

回答

質問


Undefined function 'selectStrongest' for input arguments of type 'uint8'.
While using the Surf feature i am getting this error "Undefined function 'selectStrongest' for input arguments of type 'uint8'."...

9年以上 前 | 1 件の回答 | 0

1

回答

回答済み
How to enter MATLAB code here ?
Do you want to know how to post the code in forum or in matlab???

9年以上 前 | 0

質問


Troubleshoot controlling motors with raspberry pi model B+
With raspberry pi b+ I have connected a motor driver ic board and want to control using matlab. I am using the following command...

9年以上 前 | 0 件の回答 | 0

0

回答

回答済み
Arduino support package in matlab PROBLEM
if it is showing that then the setup is not done Properly and Then try a=arduino();

9年以上 前 | 0

回答済み
Loop Raspi Camera board to continuously take picture
Thanks for the reply. After image is taken i am facing problem with the noise removal. The question is there in this link <http:...

9年以上 前 | 0

質問


Command for running l293d through raspberry pi B+ in matlab r2015a
I want to run motors connected to motor driver ic board l293d. I have assigned Gpio pins 16,20 & 21. In which 16 is enable. My c...

9年以上 前 | 0 件の回答 | 0

0

回答

質問


when using bwpropfilt it show undefined function
Hi i need to filter binary image based on area and perimeter but using the command bwpropfilt (as given in matlab website) is sh...

9年以上 前 | 0 件の回答 | 0

0

回答

質問


How to remove object from binary image based on area and perimeter
Hi everyone i am trying to make a object follower comparing with a reference image. The problem i am getting is after the final ...

9年以上 前 | 0 件の回答 | 0

0

回答

質問


Loop Raspi Camera board to continuously take picture
Hi everyone I am using Raspberry Pi B+ for an object following. Since i am new to matlab, i dont know much of commands. I want t...

9年以上 前 | 2 件の回答 | 0

2

回答

質問


Unable to connect Rapberrypi B+ to MATLAB
I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry...

10年弱 前 | 0 件の回答 | 0

0

回答

質問


I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry pi
I was trying to connect raspberry pi model B+ to my laptop using host to host connection but it shows could not detect raspberry...

10年弱 前 | 0 件の回答 | 0

0

回答