Feeds
質問
Autocode - How to make outputs a structure
Hi Guys, I am trying to autocode a block that has 2 busses as an output. However, when I go to autocode the block, it does n...
12年弱 前 | 1 件の回答 | 0
1
回答質問
Make Error - Simulink/Stateflow
Hi Guys, recently something on my computer must have changed because I have been able to previously compile stateflow based sim...
13年弱 前 | 1 件の回答 | 0
1
回答質問
Signal Builder Active Group
Anyone know of a way to change the current active group for a signal builder block? Something along the lines that would lo...
約13年 前 | 1 件の回答 | 0
1
回答回答済み
Dealing with multiple signal selection
Azzi, Thank you. This will cut down some of the run time. This will limit which of my signal generators will run. However,...
Dealing with multiple signal selection
Azzi, Thank you. This will cut down some of the run time. This will limit which of my signal generators will run. However,...
約13年 前 | 0
回答済み
Dealing with multiple signal selection
Ryan G, not sure if that solves my problem or perhaps I do not fully understand. Lets say I make a signal generator that h...
Dealing with multiple signal selection
Ryan G, not sure if that solves my problem or perhaps I do not fully understand. Lets say I make a signal generator that h...
約13年 前 | 0
質問
Dealing with multiple signal selection
Hi, I am trying to use simulink to test multiple actuators depending on the type of control, longitudinal, collective, later...
約13年 前 | 4 件の回答 | 0
