A Afonja
Followers: 0 Following: 0
Feeds
回答済み
Parameter identification with nlgreyest
I was able to ge the system identification that matches the CFD response but I would like to set some comtraints on the maximum ...
Parameter identification with nlgreyest
I was able to ge the system identification that matches the CFD response but I would like to set some comtraints on the maximum ...
5年弱 前 | 0
回答済み
Parameter identification with nlgreyest
clc clear all % i want to use this script to estimate damping fprintf('ensure all PRT parameters are correct\n') xt=0.1; %...
Parameter identification with nlgreyest
clc clear all % i want to use this script to estimate damping fprintf('ensure all PRT parameters are correct\n') xt=0.1; %...
5年弱 前 | 0
質問
Parameter identification with nlgreyest
I have a non-linear model I want to fit into an available to identify system parameters. I have used nlgreyest but the result is...
5年弱 前 | 3 件の回答 | 0
3
回答回答済み
Running Simulink model in a loop
I have found where the problem is. Very basic mistake. I wrote i=length(omega) and not i=1:length(omega). Thanks for responding...
Running Simulink model in a loop
I have found where the problem is. Very basic mistake. I wrote i=length(omega) and not i=1:length(omega). Thanks for responding...
5年以上 前 | 0
質問
Running Simulink model in a loop
I want to run a simulink model in a loop and store the output for analysis. However, I noticed that it is the result of the las...
5年以上 前 | 2 件の回答 | 0