Communicating Simulink 8.0 (2012) with Code Composer Studio (CCS v5.2)

Hi I have some problems when trying to run the simulink coder examples for Texas Instruments. I have a Delfino Card F28335 and when lauching the examples I get some erros:

1) Automation Interface Tutorial: Cannot start CCS application (COM error ID: 0x80040154). Verify that your CCS software is installed and configured properly.

This when typing "checkEnvSetup('ccs', 'F28335', 'setup')" on the matlab command 2) Your Version : NOT FOUND The required version of Flash Tools is not found in Following environment variable(s) required for code generation could not be set ### "FLASH_28335_API_INSTALLDIR"

I have Installed and re-stalled CCS V5 but I am wondering to know if actually MATLAB 2012 has problems with CCS V5 and if I should use an old version of CCS.

Thanks for any tip and comment.

Answer 1

[Kaustubha Govind]

I'm not all that familiar with the TI Adaptor, but from Antonin's comment on this previous discussion, since you are using CCS version 5, you need to run:

>> checkEnvSetup('ccsv4','F28335','setup')