How to make 1-D Look-Up Table block run repeatedly

Hello everyone,

Now I'm looking for a way to interpretate a time related values as a signal into Simulink. The data is imported from .xml table and each value have a corresponding time value. My problem - that if i use Clock block - it would appear in the simulation only once. I tried to use reminder after devide, but in this case I can't change the time intervals between repeating the signal.

I'd like to know, how can I make 1-D Look-Up Table block run more then one time? My current solution would be attached.

The constant value - last time data for this set.

Answer 1

[Chaitanya Mallela]

You can use Counter block before 1-D Look-Up Table block with Reset port enabled. When count reaches maximum value Reset port is enabled which restarts the Counter.