Error in simulink: singularity in solution

249 ビュー (過去 30 日間)
ARCHANA A N
ARCHANA A N 2019 年 8 月 2 日
コメント済み: Bhishan Wadhai 2020 年 5 月 4 日
Hi all,
Can anyone please try to help me to fix this error "Derivative of state '1' in block xxxxx/STATCOM/Controller/LPF' at time 0.0 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)". I have adjusted the step size, tolerance values all but doesnt know its significance. Also changed the intial condition value of integrator. The same error is shown with Low Pass Filter also. Please help me to fix it.
Thanks in advance.
  1 件のコメント
Bhishan Wadhai
Bhishan Wadhai 2020 年 5 月 4 日
Hello ,
I am facing same issue . Kindly know how to resolve it.

サインインしてコメントする。

回答 (1 件)

Athul Prakash
Athul Prakash 2019 年 8 月 8 日
Hi Archana,
This error most commonly happens when your solver cannot handle large fluctuations in signals. Try using ODE15s (Stiff/NDF) as your solver.
Go to model configuration parameters(Ctrl+E) > Solver and adjust
Type: Variable-step
Solver: ode15s (stiff/NDF)
This should fix the issue.
Read the Documentation for ODE15s here:
If not, you can also try:
  1. Adding a delay so that the fluctuation slows down.
  2. To find out more, try adding Port Value Display to your signal and then step through the model.
Hope it helps.

カテゴリ

Help Center および File ExchangeOrdinary Differential Equations についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by