Target communication in Simulink Real-time 2016a
1 回表示 (過去 30 日間)
古いコメントを表示
Hi,
I want to use a motion controller(with i486 inside) to be my target PC. However, the ethernet device isn't supported by MATLAB. I try to use the Ethernet adapter(from usb to ethernet with USBA88772 chip inside). The problem is that when I boot my target device, target PC shows the networking information(not system haleted error) but it cann't connect to real-time explorer. The problem is same for my serial port connection when I try the MATLAB 2014b. I think the target PC have found the hardware but it can not communicate.
I have tried the same network setting on another PC(with Intel etherent device inside) and it works. Can anyone give me some suggestions ?
Thank you!
1 件のコメント
Mounika Patel
2019 年 7 月 23 日
You can refer to below documentation link which details about the troubleshooting the problems you encounter using Simulink Real-Time product:
回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Target Computer Setup についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!