- F2806x and F28069M LaunchPad trigger the same configuration with different deafult settings.
- If your controlCard is using an F28069M (not F28069), make sure to select the correct processor under Hardware impementation > Target Hardware Resources > Build Options > Device Name. This is one change you have to do to run the following example: c28069pmsmfoc_ert.slx (https://www.mathworks.com/help/releases/R2018b/supportpkg/texasinstrumentsc2000/ug/permanent-magnet-synchronous-motor-field-oriented-control.html). You will have to make that change in the shipping example.
- In the shipping example, we also have specific GPIO sttings for the eCAP to work with Hall sensors, make sure to keep these untouched. Reselecting a different processor may reset these to default values.
- The rest will have good deafults for the kit that you are considering.
Which hardware board should I use for DRV8312?
3 ビュー (過去 30 日間)
I am using DRV8312-69M-KIT with control card F2806x ISO control card Release 0.4 that contains processor F28069MPZT. For automatic code generation, which hardware board should I use when doing settings in Matlab -- > Configuration Parameters -- > Hardware Implementation. F2806x or F28069M LaunchPad?
Antonin 2019 年 4 月 12 日
For the F2806x ControlCard, the F2806x will have better default compared to the F28069M LaunchPad.
Things to keep in mind:
I hope it helps,