how to open csv and plot contour data
6 ビュー (過去 30 日間)
古いコメントを表示
I have a large .csv data file from a measurement sensor, i want to open the file and plot the data using Matlab. The data is in contour format, such that each row is a line scan of (X) points. At the start and end of each line (row) there are "junk" values of -999.999 where nothing was measured i'd like to filter these values out also.
I'm a newb to this so any help would be appreciated.
0 件のコメント
採用された回答
Star Strider
2018 年 8 月 16 日
編集済み: Star Strider
2018 年 8 月 16 日
Example —
D = rand(100);
figure
contour(D)
To eliminate the ‘-999.999’ values, replace them with NaN values, since those will not be plotted (and likely will appear a white blank areas).
Example —
D = rand(100);
D(5:10,10:20) = -999.999;
D(D == -999.999) = NaN;
figure
contour(D)
0 件のコメント
その他の回答 (0 件)
参考
カテゴリ
Help Center および File Exchange で Contour Plots についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!