mpcDesigner scenario output disturbance

3 ビュー (過去 30 日間)
Francis Gagnon
Francis Gagnon 2018 年 2 月 1 日
回答済み: Francis Gagnon 2018 年 3 月 9 日
Hi,
I’m having a problem with the simulated scenarios of the mpcDesigner app (Model Predictive Control Toolbox). From my understanding, by default, the output disturbance model is integrated noise summed at each measured output. It should allow rejecting step-like output disturbance at any measured output in closed-loop. To illustrate, if we take the simple MIMO process model:
G = [tf(+1.9,[18 1]) , tf(+1.9,[18 1]);...
tf(-0.74,[8 1]) , tf(+0.74,[8 1])]
and keep the default output disturbance model of the mpcDesigner, any unmeasured step-like output disturbance should be rejected in steady-state. Hence, by simulating an unmeasured unit-step disturbance on the second output at t=30sec, the measured output should reach back the setpoint in steady-state (with t>>30sec). But that is not what I see in the plotted scenario. There is a static error. At t=60sec, the simulated output value is 0 while the setpoint is still 1:
For the load disturbance, there is no static error:
I’ve included the mpcDesigner session for my example in the attached files.
Thanks for your time,
Francis Gagnon.

採用された回答

Francis Gagnon
Francis Gagnon 2018 年 3 月 9 日
MathWorks gave me the answer :
" The output response plot in the MPCDesigner app (as well as the output of the "sim" command) is just the plant output "Yp". It does not include the disturbance signal "Yod". However, what the MPC Controller sees is actually "Yp + Yod" (measured). So after disturbance rejection, the MPC Controller will maintain "Yp + Yod" as it's set point at steady state.
In the case that you have sent, the value "Yp + Yod" must be maintained at "1". Since the disturbance "Yod" is 1 in this scenario, the output "Yp" will appear as "0" in the plot (such that "Yp + Yod" is maintained at the setpoint). Specifically, at t = 30 seconds in the plot you have attached, the value of "Yod" is 1, so the value of "Yp" should go to zero to allow "Yp + Yod" to be kept at the setpoint.
Refer to the following documentation page for a diagram of the above: MPC Modeling "

その他の回答 (0 件)

カテゴリ

Help Center および File ExchangeLinear Plant Specification についてさらに検索

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by