Warning: Cannot query I2C bus speed.
1 回表示 (過去 30 日間)
古いコメントを表示
Hy everybody,
I am usining a Raspberry Pi 3 Model B V1.2 and the Support Package for Raspberry Pi.
With the Matlabcommand
mypi = raspi
I can connect to my Raspberry Pi but at the first time I use this command I alwas get following warning:
Warning: Cannot query I2C bus speed.
If I use the commands
disableI2C(mypi)
enableI2C(mypi,400000)
once and clear the variable mypi and try the comment mypi = raspi again it can query the I2C bus speed (40000)
Can anyone help me so it will work at the first time? I use Matlab 2016b
Thank you very much
1 件のコメント
Morteza aliyari
2017 年 11 月 24 日
hi,i recommend enable i2c from raspberry pi terminal with: sudo raspi-config and add bus speed to your config.txt on rpi3b. it work for me.
回答 (1 件)
Manish Annappa
2017 年 9 月 7 日
In order to get more information on the issue, post the output of the following commands
a) Create connection to Raspberry Pi (for the first time)
>> mypi = raspi
b) List all the available I2C bus available and their speed
>> mypi.AvailableI2CBuses
>> mypi.I2CBusSpeed
c) Scan all the I2C buses available to get its address. '<name>' is obtained from the output of mypi.AvailableI2CBuses.
>> scanI2CBus(mypi,'<name>')
d) Create a connection to all the addresses obtained in the above step for every I2C bus.
>> i2cdac = i2cdev(mypi,'<name>','<address>')
e) Write value to every I2C bus connected in above step
>> write(i2cdac,4092)
Refer to the link below for more information on the commands:
https://www.mathworks.com/help/releases/R2016b/supportpkg/raspberrypiio/ug/use-the-i2c-interface-on-the-raspberry-pi-hardware.html
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で MATLAB Support Package for Raspberry Pi Hardware についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!