Using system() or unix() or dos() or ! inside simulink block to deploy to hardware

1 回表示 (過去 30 日間)

vcmorini 2017 年 4 月 4 日

Hello guys

Im using simulink to deploy in a raspberry pi.

If a true is read in a gpio pin, i want to execute a command on raspbery pi command line. e.g.: sudo halt

Tried to use system(), unix(), dos(), and !, in a matlab function block without success.

Any ideas ?

Help Center および File Exchange で Raspberry Pi Hardware についてさらに検索

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by