MATLAB Answers

How do I remove a certain part of my graph?

38 ビュー (過去 30 日間)
Alec Carruthers
Alec Carruthers 2017 年 3 月 3 日
回答済み: Walter Roberson 2017 年 3 月 3 日
I'm trying to plot the specific thrust and specific fuel consumption on the same graph. I have horizontal lines that start the graph and each one goes to a different x value. I was wondering if there is a way to start the graph, for each individual curve, after the horizontal lines ends? Basically how to clean this graph up.

  0 件のコメント

サインイン to comment.

回答 (1 件)

Walter Roberson
Walter Roberson 2017 年 3 月 3 日
You can use x values that start where the horizontal line ends.
If necessary, add the desired origin to the existing x values.
However, adding the desired origin will change what is shown with the data cursor, so if you need to have the data cursor show the offset relative to the place the curve begins rather than coordinates relative to the left edge of the plot, then you would need to take more steps.

  0 件のコメント

サインイン to comment.

サインイン してこの質問に回答します。

タグ


Translated by