ezplot axis

Hi,

I'm trying to use ezplot plot a symbolic function, and I will then use hold on to plot another 'picture' with it (though just using the plot function this time). The problem is that I want the axis swapped from what ezplot is chosing. Previously, I was using,

view([90 -90])

to swap the axis, however it seems to swap the next picture I plot too, which I didn't want swapped. To counter this I tried to set the axis from the start using,

ezplot(@(lam,epsy) L,[0 0.8 0.2 1]);

However this seems to cause some infinite loop, as instead of plotting almost instantly as it was previously doing, it causes my computer to make a lot of noise and takes a long time, and I always end up cancelling it before it finishes. If anyone can help I'd be very thankful,

James

(see full code below if you wish)

function StabilityPWVL(beta,n)
syms epsy lam x;
for k = 1:n
    a = int(cos(x)*(cos(k*x)),x,0,2*pi);
    b = int(cos(x)*(sin(k*x)),x,0,2*pi);
    a = a/pi;
    b = b/pi;
    f = (beta/2)^2 + ((2*lam/k)-1)^2;
    g = (a^2 + b^2)*(3*epsy/4)^2;
    L = f - g;
    figure(k)
    ezplot(@(lam,epsy) L,[0 0.8 0.2 1]);
    %h = ezplot(L,[0 0.8 0.2 1]);
    %set(h,'color','k')
    %view([90 -90])
end

Answer 1

[James Wright]

function [] = StabilityPWVL(n)
syms x
for k = 1:n
  a = double(int(cos(x)*(cos(k*x)),x,0,2*pi)/pi);
  b = double(int(cos(x)*(sin(k*x)),x,0,2*pi)/pi);
  L = @(lam,epsy) ((2*lam/k)-1).^2 - (a^2 + b^2)*(3*epsy/4).^2;
  figure(k)
  ezplot(L,[0.2 1],[0 0.8])
end