Error occurred when evaluating apply callback [Instrument Control Toolbox]
19 ビュー (過去 30 日間)
古いコメントを表示
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/152877/image.png)
I'm trying to send data on my serial port through Simulink with the toolbox in description, but when i configure the Serial Configuration Block, it give me this error. I don't think the problem can be the port, because i have atteched an Arduino Uno.
6 件のコメント
Mojtaba
2016 年 8 月 10 日
I also have the same problem trying to connect to a virtual port for Ti MSP430 launchpad.
回答 (5 件)
Juan Martinez
2016 年 10 月 18 日
編集済み: Juan Martinez
2016 年 10 月 18 日
For anyone reading this I used to have this same problem; however, I think I found the solution. Simply connect your hardware (Arduino) to the computer before opening Matlab. Then (with the hardware connected) open Matlab, then open your Simulink model and configure the Serial Configuration Block, it should work just fine now. After doing so, you can save your Simulink model and the serial configuration will be saved as well.
8 件のコメント
Robert Sawrey
2016 年 8 月 18 日
I had this problem, then ran Matlab in Administrator Mode, which fixed the issue.
Madhu Govindarajan
2015 年 12 月 28 日
Have you tried using the Arduino Serial Transmit instead of the Instrument Control Toolbox one? I think that will resolve this issue.
Fox Hsu
2016 年 1 月 26 日
i have the same problem. In my case, it turns out it's the conflict between 2 serial ports ( i'm trying to open 2 serial port in the same simulink model) cause this error message.
0 件のコメント
参考
カテゴリ
Help Center および File Exchange で Instrument Control Toolbox についてさらに検索
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!